Epiphan Lecture Recorder x2 Guide de l'utilisateur télécharger pdf (Page 23)

Getting Started

Lecture Recorder x2 User Guide

1. Start a web browser on any workstation connected to the same network as

the Lecture Recorder x2.

2. Browse to the Lecture Recorder x2.

http://<ip address of the Lecture Recorder x2>/admin

The IP address of the Lecture Recorder x2 can be obtained using any of the

following methods:

a. The Epiphan Network Utility

b. The EpiphanTouch app

c. From the network administrator

d. Using the Factory Default static IP address. Only if the steps in

section, Connecting Directly to the Lecture Recorder x2, are

followed

3. Log in as the Lecture Recorder x2’s administrator user

User Name: admin

Password: configured password<return>, there is no factory default

password so unless a password has been configured, just hit <return>

The Web admin Interface opens.

4.5 Users Logging

The Lecture Recorder x2 comes with three pre-configured users which can log in the

control interface. The first is the administrator user, the user name is admin. The

second is the operator user, the user name is operator. The third is the viewer user,

the user name is viewer. Each can be assigned a password but their user names

cannot be altered. It is not possible to create new user names.

Important: When you install firmware for the first time after purchasing the device,

no default passwords are set.

4.5.1 The Administrator User

The administrator user is granted rights to log into the Lecture Recorder x2 and

perform any of the following functions:

1. Perform configuration changes to the Lecture Recorder x2.

2. Manage the current broadcast. This can include the starting or stopping of the

recording of the broadcast.

3. Manage previously recorded broadcasts. Including the archiving of recordings.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 140 141

Pas de commentaire

Epiphan Lecture Recorder x2 Guide de l'utilisateur Page 23